Bridge Saw 620
A five-axis bridge saw built for production fabricators — cutting, mitring and profiling stone, porcelain and sintered surface to ±0.2 mm, day after day.
Built to hold a line through a full shift — not to win a spec sheet. The 620 is the saw a production floor leans on.
Rigid bridge, hardened linear rails and a 15 kW direct-drive spindle keep the blade true at depth. The B+C rotary head takes it from straight cuts to mitres, drains, splashbacks and shaped profiles without re-fixturing.
Supplied, installed, commissioned and serviced by Arcera across New Zealand and Australia — with parts and a trade desk in both regions.
The numbers that matter on the floor
One machine across the materials a fabricator actually runs.
Benchtops
Kitchen & bathroom tops with mitred edges and cut-outs.
Large-format
1200 × 2400 porcelain panels, scored and split clean.
Architectural
Facade, cladding and feature stone to spec.
Custom & monumental
Profiled, shaped and one-off commissions.
Site requirements
We confirm every one of these with you before delivery. A short site survey avoids surprises on install day.
Request a site surveyPower
400V 3-phase, 32A on a dedicated isolator.
Water & slurry
Recirculation tank or mains feed, plus drainage and slurry management.
Floor
Level reinforced slab ≥150 mm, rated for 6.8 t plus point loads.
Access & rigging
Forklift or crane access for delivery and a 6.8 t lift into position.
Footprint
5.6 × 4.2 m plus ~1 m working clearance on all sides.
Environment
Covered, 5–40°C, with compressed air at 6 bar available.